- This topic has 0 則回覆, 1 個參與人, and was last updated 5 years, 7 months 前 by
.
-
文章
-
（1）WiFi對MWS的干擾
從WiFi（2.4 / 5GHz頻段）到微波傳感器（MWS）的干擾小到可以忽略不計。 MWS有一個帶通濾波器，以減少這些無線電設備的干擾。
⇒如果有乾擾，請在評估後確保安全距離。請安裝MWS模塊。<注意>
①MWS未使用終端的處理：
如果未使用Comp_Th（PIN 1）和Comp_out（PIN 5）兩個端子，請不要將CABLE連接到連接器並使其處於OPEN狀態。
②請勿將MWS板直接安裝在金屬表面（包括絕緣塗層等）上。請插入1毫米或以上的絕緣墊片。（2）從MWS到WiFimodule的干擾MWS是一個24 GHz頻段，它的工作頻率是WiFimodule的四倍以上，而且是一個小的無線電輸出。 WiFimodule不再適用於此無線電頻率。因此，WiFi模塊不會產生足夠的信號失真來引起MWS的干擾，因此不會受到MWS的干擾
(1) Interference from WiFi to MWS
Interference from WiFi(2.4/5GHz band) to microwave sensor (MWS) is negligibly small. MWS has a band-pass filter to reduce interference from these radio devices.
⇒If there is interference, ensure the secure distance after evaluation.Please install he MWS module.<Notes>
①Treatment of unused terminal of MWS:
If both terminals Comp_Th(PIN 1) and Comp_out(PIN 5) are not used, please do not connect CABLE to the connector and leave them in the OPEN state.
②Do not install this MWS board directly on a metal surface (including insulation coating etc.). Please insert insulation spacer of 1 mm or more.(2)Interference from MWS to WiFimodule MWS is a 24 GHz band, it operates at a high frequency more than four times the WiFimodule, and it is a small radio output. The WiFimodule no longer works at this radio frequency.As a result, the WiFi module does not generate enough signal distortion to cause interference from the MWS, so there is no interference from the MWS.
- 抱歉，回覆主題必需先登入。